Ohio Ornamental Drive Gates by JDR Metal Art

Columbus Ohio Ornamental Drive Gates by JDR Metal Art

We just finished fabrication and powder coating of these new dual swing ornamental drive gates. They were purchased as a anniversary gift and were installed at our client’s new residential property outside Columbus, Ohio.

Drive Gate Installation

Foundation is the Key to Success!

Due to the fact that these plasma cut gate panels are each built 10′ wide and over 6′ tall, there will be a tremendous amount of weight hanging freely in the air that needs to be properly supported by the posts set into the ground. Concrete is cheap and this type of application calls for plenty of it.

Our post holes are a minimum of 4′ deep. We always want to get as far down as reasonably possible in order to ensure that there is enough room to hold all the concrete we want to put around and beneath our gate posts.

Each post hole is 16″ wide at the top and flares out to 2′ wide at the bottom. The bell shape below the frost line prevents the gates from leaning over time. It takes about a half ton of concrete to fill each of our post holes. Each of these particular plasma cut drive gate panels weigh just under 300 lbs while the posts each weigh 100 lbs.

We always prefabricate the drive gate posts and hinges so they are ready to bolt together on the job site for a relatively simple installation. We set the gates to the desired height using wood blocks as shims to get the gate level in its place. Next we drop the post in its hole and there assemble the post to the gate with bolts and nuts through the hinges. The gate is then held plum while the hole is filled with concrete. The same procedure is completed with the second gate panel…now everything is perfectly lined up and the concrete cures for at least 24 hours before the shims are ready to be removed from underneath to let the gates hang freely. At that point the drive gate openers are ready to be installed.

JDR Metal Art Supplies Custom Designed Drive Gates Worldwide

We crate and ship our custom built drive gates worldwide at the most competitive rates available. We use carriers such as UPS Freight, FedEx Freight, Yellow Roadway and many others. We can also personally deliver our gates for a fee. We offer free local pickup in central Ohio for our customers from the surrounding states.

20150601_143528

Ready to begin? Contact us:

Ex.: Wildlife, Pets, Equine, Trees, Farm, Ranch, Residential, Simple, Traditional, etc.

Automatic Driveway Gates | Whitetail Gate Design

Automatic Driveway Gates with Decorative Deer Silhouettes

Here at JDR Metal Art we built these custom automatic driveway gates for a beautiful residence in north central Ohio in the spring of 2012. It is made from steel material and plasma cut by hand with a Hypertherm plasma cutter. The overall width is 20′ and the top of the gate towers approximately 7′ above grade. It is solar powered by Liftmaster dual swing gate openers, It can be activated by remote controls, a keypad, and an automatic exit sensor.

Custom Automatic Driveway Gates & Designs

We can custom design any gate themes you may have in mind, including but not limited to wildlife gates, equine gates, and tree gates. We are able to alter almost all of our existing designs to suit the size needs of your driveway entrance. We also make custom wrought iron gate designs from scratch if you are interested.

Rustic automatic driveway gates featuring cutouts of deer fox and trees plasma cut by JDR Metal Art.

All of our automatic driveway gates are pretreated, primed and powder coated for long lasting beauty and durability. They are ready to have openers mounted to them and power supplied for hands-free entry and exit with the proper automation equipment. A keypad and automated exit sensor are highly recommended for visitors. Handheld transmitters can be supplied to allow operation from the comfort of a vehicle.

To contact JDR Metal Art:

Ex.: Wildlife, Pets, Equine, Trees, Farm, Ranch, Residential, Simple, Traditional, etc.